Dell Networking 103 Series Access Points - Access Point|Dell Access Point

Dell Networking 103 Series Access Points
Operating modes
• 802.11a/b/g/n Instant AP
• 802.11a/b/g/n Controller-managed AP
• Air monitor (AM) for wireless IDS, rogue detection and containment
• Spectrum analyzer
• Secure enterprise mesh
• Remote AP (RAP) when used with a Controller
Wireless radio specifications
• AP type: Indoor, dual radio, 5GHz and 2.4GHz 802.11n 2x2:2
• Software-configurable dual radio supports 5GHz (Radio 0) and 2.4GHz (Radio 1)
• 2x2 MIMO with two spatial streams and up to 300 Mbps wireless data rate
• Supported frequency bands (country-specific restrictions apply):
• 2.4000 to 2.4835GHz
• 5.150 to 5.250GHz
• 5.250 to 5.350GHz
• 5.470 to 5.725GHz
• 5.725 to 5.850GHz
• Available channels: Dependent on configured regulatory domain
• Dynamic frequency selection (DFS) optimizes the use of available RF spectrum
• Supported radio technologies:
• 802.11b: Direct-sequence spread-spectrum (DSSS)
• 802.11a/g/n: Orthogonal frequency-division multiplexing (OFDM)
• Supported modulation types:
• 802.11b: BPSK, QPSK, CCK
• 802.11a/g/n: BPSK, QPSK, 16-QAM, 64-QAM
• Transmit power: Configurable in increments of 0.5 dBm
• Maximum (aggregate, conducted total) transmit power (limited by local regulatory requirements):
• 2.4GHz band: +21 dBm (18 dBm per chain)
• 5GHz band: +21 dBm (18 dBm per chain)
• Advanced Cellular Coexistence (ACC) minimizes interference from cellular networks
• Maximum ratio combining (MRC) for improved receiver
performance
• Cyclic delay/shift diversity (CDD/CSD) for improved downlink RF performance
• Short guard interval for 20-MHz and 40-MHz channels
• Space-time block coding (STBC) for increased range and improved reception
• Low-density parity check (LDPC) for high-efficiency error correction and increased throughput
• Supported data rates (Mbps):
• 802.11b: 1, 2, 5.5, 11
• 802.11a/g: 6, 9, 12, 18, 24, 36, 48, 54
• 802.11n: 6.5 to 300 (MCS0 to MCS15)
• 802.11n high-throughput (HT) support: HT 20/40
• 802.11n packet aggregation: A-MPDU, A-MSDU
Power
• Maximum power consumption: 9.5W (POE) or 8W (DC)
• Power sources sold separately
• Direct DC source: 12 Vdc nominal, +/- 5%
• Power over Ethernet (PoE): 48 Vdc (nominal) 802.3af or 802.3at-compliant source
Antennas
• Four integrated down-tilt omni-directional antennas for 2x2 MIMO with maximum antenna gain of 3.9 dBi at 2.44GHz, 4.1 dBi at 5.2GHz and 4.3 dBi at 5.8GHz. Built-in antennas are optimized for horizontal ceiling mounted orientation of the AP.
Other interfaces
• 10/100/1000BASE-T Ethernet network interface (RJ-45)
- Auto-sensing link speed and MDI/MDX
- 802.3az Energy Efficient Ethernet (EEE)
- PoE-PD: 48 Vdc (nominal) 802.3af PoE or 802.3at PoE+
• DC power interface, accepts 1.7/4.0-mm centerpositive circular plug with 9.5-mm length
• Serial console interface (proprietary; optional adapter cable available)
• Visual indicators (LEDs):
- Power/system status
- Ethernet link status (ENET)
- Radio status (two; RAD0, RAD1)
• Kensington security slot
• Reset button
Mounting
• Included with AP:
- Mounting brackets (2) for attaching to 9/16-inch or 15/16-inch T-bar drop-tile ceiling
• Spare mounting kit:
- AP-220-MNT-C1: AP mounting kit contains two
ceiling-grid rail adapters for flat rails
• Optional mounting kits:
- AP-220-MNT-C2: AP mounting kit contains two ceiling-grid rail adapters for Interlude and Silhouette style rails
- AP-220-MNT-W1: AP mounting kit contains one basic flat-surface wall/ceiling mounting bracket
Mechanical
• Dimensions/weight (unit, excluding mounting accessories):
- 150 mm (W) x 150 mm (D) x 41.5 mm (H)
- 5.9” (W) x 5.9” (D) x 1.63” (H)
- 300 g (0.66 lbs)
• Dimensions/weight (shipping):
- 192 mm (W) x 178 mm (D) x 68 mm (H)
- 7.6” (W) x 7.0” (D) x 2.68” (H)
- 500 g (1.10 lbs)
Environmental
• Operating:
- Temperature: 0° C to +40° C (+32° F to +104° F)
- Humidity: 5% to 95% non-condensing
• Storage and transportation:
- Temperature: -40° C to +70° C (-40° F to +158° F)
Regulatory
• FCC/Industry of Canada
• CE Marked
• R&TTE Directive 1995/5/EC
• Low Voltage Directive 72/23/EEC
• EN 300 328
• EN 301 489
• EN 301 893
• UL/IEC/EN 60950
• EN 60601-1-1 and EN 60601-1-2
Regulatory model number
• W-AP103 and W-IAP103: APIN0103
Certifications
• CB Scheme Safety, cTUVus
• Wi-Fi Alliance (WFA) certified 802.11a/b/g/n
Warranty
• Extended lifetime warranty
Minimum operating system software versions
• AOS 6.4.0.1
• InstantOS 4.1.0.0